3d print wont stick or How to Get Prints to Stay Down

3D Print Stick PEI

3d print wont stick or bed adhesion is sometimes very hard to get right when 3D Printing. Here are the best ways we have found to get your 3d prints to stick no matter what… We often get asked this and see a lot of posts on the web about how to get 3D Prints […]

Read More…

Octoprint vs Astroprint Control your 3D Printer Remotely

3d printer remote control

Octoprint vs Astroprint what are the differences, how to do choose and what’s the best option for you. These article will discuss the two web interfaces that allow you to remotely control your 3d printer from anywhere! Octoprint is an open source project started by Gina Häußge a.k.a foosel over 5 years ago. Astroprint is a company […]

Read More…

MKS Gen V1.4 3D Printer MainBoard Controller

mks main board 3d printer

MKS Gen V1.4 is made by a Chinese manufacturer Makerbase. MKS (Makerbase) are manufacturers of 3D Printer controller board also know as mainboards that run Marlin, Repetier and other firmware. MKS Gen V1.4 Overview This is an 8-bit control board for your 3d printer with an Atmel Mega 2560 micro controller. Buy this board on Amazon for only $34.59! This […]

Read More…